Anything that cannot penetrate through the sand is trapped there. Water will pass through with ease, but any larger particles will get stuck on the way.
Quickly learn how to drain your pool when using a sand filter.
How to drain an above ground pool with a sand filter. The filtration process works in a way that all the dirt and debris are trapped by the sand while the clean and filtered water is returned to the pool. You connect the vacuum hose to the suction side of the pool, normally at the bottom of the skimmer. Watch as the water flow reverses and starts draining the pool.
Now with all of these extra ports open you can turn on the blower again which will cause some mist to blow out of the ports on your filter. Water cycles through a canister filled with sand. To drain it manually, lay plastic sheeting underneath the filter drain assembly, remove the assembly and turn on the pump.
Roll backwash hose out into the yard or approved draining area. Put the other end in your swimming pool. This is the fastest, but messiest way to get rid of the sand from your system.
How to drain a pool with a sand filter. So you’ll need to completely drain all the water from the tank by unscrewing and removing the drain. To winterize your sand filter, remove the drain cap at the bottom of the filter tank to let the entire filter drain and leave the drain cap off until spring.
After you get the correct amount of water out of your swimming pool, turn the pump back off. Rotate the multiport valve on the top or side in a clockwise direction to the “waste” position. To vacuum a pool with a sand filter you will need a vacuum head, a pool pole and a vacuum hose.
Please view our cartridge filter video for a full drain demonstration. You’ve now sorted out the top mount valve of your filter pump, but your filter tank is still full of water. A sand pool filter uses sand as a filter, trapping larger debris that tries to pass through so that only clean water gets back to the pool.
3) turn off the blower and change the filter head setting to winter. Intex krystal clear sand filter pump for above ground pools. After the water has drained, you can add more if needed and repeat this process until it’s clean enough to swim in without feeling any dirt or other particles on your skin.
Turn the pump back on. You can now remove both hoses that connect the filter to the pool. For less mess, try removing the drain plug and allowing the sand to drain for a few days.
A pool sand filter consists of a container of sand that the pool water filters through. This video will show you how to use the different settings to backwash and clean your above ground pool sand filter.in the swim pool product offer: Ideally, only water can seep through.
Turn on the water so it flows into the pool (removes air from the pipe) detach the end of hose from the faucet and immediately lower it to the ground. This process uses a sand filter pump in order to pump the dirty and unclean water out of the pool. This water isn’t going to store well through the winter.
If you have a bleeder valve or air vent valve on your sand filter you should open this as well. Then gently move the vacuum around the bottom of the pool sucking up the dirt as you go. After laying out the filter sand inside of your pool’s filter tank, add in some water and let it settle into place.
Thereby giving you a lot more control of how to treat and maintain your swimming pool water. That is of course a very simplified explanation. The flow of the pump is 1.2k gallons per hour.
How to (or how not to) move a full above ground hayward pool sand filter and pump (300++ lbs). Connect one end of the hose to your faucet. Move the valve handle at the top of the filter to the “winter” position.